Mdc Commands; Mdc Commands For The Default Mdc; Allocate Interface - HPE FlexNetwork 10500 series Command Reference Manual

MDC commands

Do not configure MDCs on a device installed with the following cards, or install the following cards on
a device configured with MDCs:
•
EA interface modules:
LSU1GP24TXEA0(JC621A, JG380A).
LSU1GP48EA0(JC622A, JG381A).
LSU1GT48EA0(JC623A, JG382A).
LSU1TGX4EA0(JC624A, JG383A).
•
EB interface modules.
•
SC interface module: LSU1TGS16SC0(JC628A).
•
SE interface modules:
LSU1GP24TSE0(JC763A, JG347A).
LSU1GP24TXSE0(JC617A, JG376A).
LSU1GP48SE0(JC619A, JG378A).
LSU1GT48SE0(JC618A, JG377A).
LSU1TGX4SE0(JC620A, JG379A).

MDC commands for the default MDC

This section describes the MDC commands that you can use after logging in to the default MDC (the
physical device).
Unless otherwise stated, the term "MDC" in this section refers to a non-default MDC.

allocate interface

Use allocate interface to assign a physical interface to an MDC.
Use undo allocate interface to reclaim a physical interface assigned to an MDC.
Syntax
allocate interface { interface-type interface-number }&<1-24>
undo allocate interface { interface-type interface-number }&<1-24>
allocate interface interface-type interface-number1 to interface-type interface-number2
undo allocate interface interface-type interface-number1 to interface-type interface-number2
Default
All physical interfaces on the device belong to the default MDC. A non-default MDC cannot use any
physical interfaces.
Views
MDC view of a non-default MDC
Predefined user roles
network-admin
mdc-admin
43