Specifying A Memory Space Percentage For An Mdc; Accessing An Mdc - HPE FlexFabric 12900E Series Configuration Manual

limit-resource cpu weight weight-value
The defaults are as follows:
The default MDC has a CPU weight of 10 on each MPU and each LPU.

Each non-default MDC has a CPU weight of 10 on each MPU and each assigned LPU.

The CPU weight for the default MDC is fixed at 10 and cannot be changed.

Specifying a memory space percentage for an MDC

About specifying memory space percentages
The MDCs on a device share and compete for the system memory space. If an MDC occupies too
much memory space, the other MDCs might not be able to operate correctly. To avoid this problem,
specify a memory space percentage for each MDC.
Prerequisites
Before you specify a memory space percentage for an MDC, use the
command to view how much memory space the MDC is using. Make sure the memory space you
assign to an MDC is sufficient for the MDC to operate correctly.
The amount of memory space assigned to an MDC must be greater than the amount of memory
space the MDC is using. As a best practice, execute the
the MDC starts up to identify the minimum memory space requirements.
Procedure
1. Display the memory space usage of the MDC.
In standalone mode:
display mdc [ name mdc-name ] resource [ memory ] [ slot slot-number ]
In IRF mode:
display mdc [ name mdc-name ] resource [ memory ] [ chassis
chassis-number slot slot-number ]
This command is available in any view.
2. Enter system view.
system-view
3. Enter MDC view.
mdc mdc-name [ id mdc-id ]
4. Specify a memory space percentage for the MDC.
In standalone mode:
limit-resource memory slot slot-number ratio limit-ratio
In IRF mode:
limit-resource memory chassis chassis-number slot slot-number ratio
limit-ratio
By default, all MDCs share the memory space in the system, and an MDC can use all free
memory space in the system.

Accessing an MDC

About accessing an MDC
This feature enables you to log in to a non-default MDC from the system view of the default MDC.
display mdc resource
58
display mdc resource
command after