Irf Auto-Merge Enable - HPE FlexNetwork 10500 series Command Reference Manual

Ten-GigabitEthernet2/3/0/25
Ten-GigabitEthernet2/7/0/45
MAD ARP enabled interface:
Vlan-interface4
MAD ND disabled.
MAD LACP disabled.
MAD BFD enabled interface: Vlan-interface3
MAD status
Member ID
1
2
Table 7 Command output
Field
Multi-active recovery state
Excluded ports (user-configured)
Excluded ports
(system-configured)
MAD status
Member ID
Port
Neighbor

irf auto-merge enable

Use irf auto-merge enable to enable IRF auto-merge.
Use undo irf auto-merge enable to disable IRF auto-merge.
Syntax
irf auto-merge enable
undo irf auto-merge enable
Default
IRF auto-merge is enabled. The IRF fabric that has failed in the master election reboots
automatically to complete the IRF fabric merge.
: Faulty
MAD IP address
88.1.1.1/24
88.1.1.2/24
Description
Whether the IRF fabric is in Recovery state.
•
Yes—The IRF fabric is in Recovery state. When MAD detects that
an IRF fabric has split into multiple IRF fabrics, it allows one fabric
to forward traffic. All the other IRF fabrics are set to the Recovery
state. In Recovery state, MAD shuts down all physical ports in the
fabric except for the IRF physical interfaces and ports configured to
not shut down.
•
No—The IRF fabric is not in Recovery state. The fabric is active
and can forward traffic.
Ports manually configured to not shut down when the IRF fabric transits
to the Recovery state.
Ports set to not shut down by default when the IRF fabric transits to the
Recovery state.
MAD link status:
•
Normal—The MAD link is operating correctly.
•
Faulty—The MAD link is faulty. Check the interface or port for
connectivity or configuration problems.
•
N/A—MAD link status cannot be detected. This field always
displays N/A if BFD MAD is enabled on a management Ethernet
port.
IRF member ID of the local device.
Member ports of the aggregate interface used for LACP MAD.
IRF member ID of the neighbor member device.
Neighbor MAD status
2 Faulty
1 Faulty
9