Irf Auto-Update Enable - HPE FlexNetwork 10500 series Command Reference Manual

Virtual technologies

Hide thumbs Also See for FlexNetwork 10500 series:

Security command reference (881 pages)

Security configuration manual (702 pages)

Network management and monitoring command reference (423 pages)

Table Of Contents

Table of Contents

Views

System view

Predefined user roles

network-admin

mdc-admin

Usage guidelines

If the IRF auto-merge feature is disabled, you must follow the system instructions to manually reboot

member devices in the IRF fabric that fails master election.

For a successful merge, make sure IRF auto-merge is enabled on both IRF fabrics that are merging.

This command is supported only in IRF mode. When you change the operating mode from IRF to

standalone, the setting for this command is lost, regardless of whether you have saved the

configuration. To disable IRF auto-merge after you change the operating mode from standalone to

IRF, use the undo form of this command.

IRF auto-merge takes effect on merges caused by the following events:

•

The IRF link recovers from a link failure.

•

The IRF physical interfaces of the member devices are connected after the interfaces are

bound to IRF ports.

The feature does not take effect on a merge that occurs in the following conditions:

•

You bind a physical interface to an IRF port.

•

The interface has been connected to the peer IRF physical interface before the binding

operation.

Examples

# Enable IRF auto-merge.

<Sysname> system-view

[Sysname] irf auto-merge enable