Pex-Port - HPE FlexNetwork 10500 series Command Reference Manual

Parameters
switch: Specifies the switch operating mode. In this mode, the specified devices operate
independently. It is not part of an eIRF system, whether or not it has connections to the parent fabric.
all: Specifies all PEXs.
chassis chassis-number: Specifies a PEX by its virtual chassis number. Available values are the
virtual chassis numbers of all PEXs.
slot slot-number1: Specifies a PEX in the virtual chassis. In the current software version, a virtual
chassis can contain only one PEX.
slot slot-number1 to slot-number2: Specifies a range of PEXs in the virtual chassis. In the current
software version, a virtual chassis can contain only one PEX.
Usage guidelines
This command does not change the current operating mode of specified PEXs. For the mode
change to take effect, you must reboot the PEXs. After the PEXs reboot, you must save the
configuration for the configuration to survive a reboot.
To cancel the mode change configuration, use the undo form of this command before you reboot the
device. However, the undo command takes effect after the PEXs reboot.
Examples
# Set the operating mode to switch for the PEX in virtual chassis 100.
<Sysname> system-view
[Sysname] pex working-mode switch chassis 100 slot 0
Are you sure you want to force a change to switch mode?[Y/N]: y
If you want to change PEX device to switch mode, you must reboot the device.
[Sysname] quit
<Sysname> reboot chassis 100

pex-port

Use pex-port to create a PEX port and enter PEX port view. If the port has been created, the
command only places you in PEX port view.
Use undo pex-port to delete a PEX port.
Syntax
pex-port pex-port-id
undo pex-port pex-port-id
Default
No PEX ports exist.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
pex-port-id: Specifies a PEX port number in the range of 1 to 120.
38