Location - HPE FlexNetwork 10500 series Command Reference Manual

Parameters
slot slot-number: Specifies a card. (In standalone mode.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. (In IRF
mode.)
cpu cpu-number: Specifies a CPU by its number. If you do not specify this option, the command
specifies a memory space percentage for CPU 0.
ratio limit-ratio: Specifies the ratio of the memory space that an MDC can use on the specified card
to the total memory space of the card. The value range is 1 to 100.
Usage guidelines
This command sets the maximum amount of memory space that an MDC can use. Make sure this
amount is sufficient for the MDC to operate correctly.
Examples
# (In standalone mode.) Allow MDC sub1 to use up to 30 percent of the memory space on the card in
slot 1.
<Sysname> system-view
[Sysname] mdc sub1
[Sysname-mdc-2-sub1] limit-resource memory slot 1 ratio 30
# (In IRF mode.) Allow MDC sub1 to use up to 30 percent of the memory space on the card in slot 1
on IRF member device 2.
<Sysname> system-view
[Sysname] mdc sub1
[Sysname-mdc-2-sub1] limit-resource memory chassis 2 slot 1 ratio 30

location

Use location to assign an LPU to an MDC.
Use undo location to reclaim an LPU from an MDC.
Syntax
In standalone mode:
location slot slot-number
undo location slot slot-number
In IRF mode:
location chassis chassis-number slot slot-number
undo location chassis chassis-number slot slot-number
Default
All LPUs of the device belong to the default MDC. A non-default MDC cannot use any LPUs.
Views
MDC view of the default MDC or a non-default MDC
Predefined user roles
network-admin
mdc-admin
Parameters
slot slot-number: Specifies an LPU. (In standalone mode.)
51