chassis chassis-number slot slot-number: Specifies an LPU on an IRF member device. (In IRF
mode.)
Usage guidelines
To assign physical interfaces to an MDC, you must authorize the MDC to use the LPUs to which the
physical interfaces belong.
To return an LPU that has been assigned to a non-default MDC to the default MDC, you must
perform the following tasks:
1.
Use the undo location command to reclaim the LPU.
2.
Use the location command to assign the LPU to the default MDC.
Examples
# (In standalone mode.) Authorize MDC sub1 to use the LPU in slot 3.
<Sysname> system-view
[Sysname] mdc sub1
[Sysname-mdc-2-sub1] location slot 3
# (In IRF mode.) Authorize MDC sub1 to use the LPU in slot 3 on IRF member device 2.
<Sysname> system-view
[Sysname] mdc sub1
[Sysname-mdc-2-sub1] location chassis 2 slot 3
switchto mdc
Use switchto mdc to log in to a non-default MDC from the system view of the default MDC and enter
MDC user view.
Syntax
switchto mdc mdc-name
Views
System view
Predefined user roles
network-admin
network-operator
Parameters
mdc-name: Specifies the MDC name, a case-insensitive string of 1 to 15 characters.
Usage guidelines
You can log in to an MDC only when it is in active state.
Examples
# Log in to MDC sub1 from the system view of the default MDC.
<Sysname> system-view
[Sysname] switchto mdc sub1
******************************************************************************
* Copyright (c) 2010-2015 Hewlett Packard Enterprise Development LP
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
52
*
*
*