Shure ANI22-BLOCK User Manual page 28

Shure Publications | User Guides | ANI22
http://pubs.shure.com/guide/ANI22/en-US
< SET LED_BRIGHTNESS n >
ANI22 Response:
< REP LED_BRIGHTNESS n >
Get Audio Clip Indicator
Command String:
< GET xx AUDIO_OUT_CLIP_INDICATOR
>
ANI22 Response:
< REP xx AUDIO_OUT_CLIP_INDICATOR
ON >
< REP xx AUDIO_OUT_CLIP_INDICATOR
OFF >
Get Audio IP Address
Command String:
< GET IP_ADDR_NET_AUDIO_PRIMARY >
ANI22 Response:
< REP IP_ADDR_NET_AUDIO_PRIMARY
{ yyyyyyyyyyyyyyy } >
Get Audio Subnet Address
Command String:
< GET IP_SUBNET_NET_AUDIO_PRIMARY >
ANI22 Response:
< REP IP_SUBNET_NET_AUDIO_PRIMARY
{ yyyyyyyyyyyyyyy } >
Get Audio Gateway Address
Command String:
< GET IP_GATEWAY_NET_AUDIO_PRIMARY
>
ANI22 Response:
< REP IP_GATEWAY_NET_AUDIO_PRIMARY
{ yyyyyyyyyyyyyyy } >
Get Limiter Status
Command String:
< GET LIMITER_ENGAGED >
0 = LED disabled
1 = LED dim
2 = LED default
Where xx is ASCII channel number: 00
through 04.
The ANI22 will respond with one of these
strings.
Where yyyyyyyyyyyyyyy is a 15 digit IP
address.
Where yyyyyyyyyyyyyyy is a 15 digit subnet
address.
Where yyyyyyyyyyyyyyy is a 15 digit
gateway address.
Indicates if the limiter is currently reducing
the signal level.
9/12/17, 9(22 AM
Page 28 of 35