Level; Hold Off; Cursors; Cursor Control - Fluke PM3082 Service Manual

2 - 1 0
CHARACTERISTICS
2.3.7

Level

LEVEL CONTROL
RANGE MTB EDGE
Unless in Level-p(eak)p(eak)
TV
LEVEL CONTROL
RANGE DTB EDGE
TRIGGERLEVEL
Accuracy
Triggergap
Note 1: The control range of the trigger level is related to the peak-peak value and duty cycle ol
the trigger signal.
2.3.8

Hold Off

HOLDOFF SETTING
Minimum
Maximum
2.4

CURSORS

Cursor Control

2.4.1
NUMBER OF CURSORS
CURSOR MODES
Manual
Measure
Note 1: In the "MTB + DTB" and "DTB" timebasemode, all waveform operations are performed on
DTB traces.
Note 2: The ratio range is 0% ... 999% where 100% corresponds to the value in the cursor read
out at the moment that the "AT=100%"- or "AV=100%"-button is pushed.
Note 3: The phase range is C P ... 999° where 36CP corresponds to the value in the cursor read out
at the moment that the "AT=36CP "-button is pushed.
Note 4: Amplitude cursors track the min. and max. value of the signal; not possible with DTB on.
SPECIFICATION
± 8 div
Note 1
Fixed
± 8 div
<0.2 div
0.4 div
2 us or 3 div. of
MTB setting
2 s or 20 div. of
MTB setting
4
Amplitude
Time
Both
Vpp
CHARACTERISTICS
ADDITIONAL INFORMATION
at 1 MHz input signal
triggercoupling DC.
at 1 MHz input signal; in noise
triggering multiply by 2.
Whichever is greater
Whichever is smaller
See note 1
AV, V1&V2 to GND,ratio
AT, 1/AT, Ratio, Phase
See note 2 and 3
AVpp, Vp+&Vp- to GND
Vdc to GND
Risetime 10%-90%
20%-80%
See note 4