Oki MC573 Advanced Manual page 344

Item
DRD Type
Dial Tone Detection* 2
Busy Tone Detection
Monitor Control
Monitor Volume
TTI Register / TTI 1
Edit
TTI 2
TTI 3
Standard TTI
TTI Number
TTI Calendar Type
Super G3
Wireless Module
Erase Privacy Data* 1
Factory Description
default
setting
Type 1 Set Distinctive Ring Detection.
Type 1
Type 2
Type 3
Type 4
OFF Sets whether to detect a dial tone.
ON Sets whether to detect a busy tone.
OFF Select from three choices.
OFF: Not to monitor.
Type 1: To monitor for about five seconds after
being connected to the sender when receiving
faxes or from the time you are connected to
the receiver to the time the fax signal is
received when sending faxes.
Type 2: To monitor all the time.
Middle Sets the Monitor Volume.
OFF
Low
Middle
High
(NULL) Registers or changes the transmission
terminal identification (the name of a sender).
You can enter up to 22 characters.
TTI 1 Selects the default sender's name from the
registered list.
TTI 1
TTI 2
TTI 3
(NULL) Register the fax number of this machine.
dd/mm/yyyy or Sets the calendar date format of sender's
mm/dd/yyyy information.
ON Sets whether to use Super G3 (ultra high-
speed communication mode).
Disable Sets whether to enable or disable wireless
LAN.
- Deletes the registered privacy data.
• Data saved to E-mail address list,
phonebook, profile, one-touch buttons
• Values set to the Admin Password and other
menu items.
• Fax communication data
• Various histories
• Access control information and user
information registered to the device
*1 A message is displayed to confirm the equipment restarts. Select [Yes] to continue. Select [No] to cancel.
*2 When you set the dial tone detection setting to [ON], the machine does not dial if the dial tone is not detected.
Business Phone Setup
Item
Business Phone Cooperation Disable
Connection IP Address 0.0.0.0
Connection Port No. 59000
- 344 -
9. Operating Management/ Specifications
Factory default setting Description
Sets whether to enable Business
Phone Cooperation.
Sets the IP address of the connected
device.
Sets a port number of the connected
device.