Equipment Compartment - HotSpring LimeLight GLEAM Owner's Manual

Activate the clean cycle again to circulate the spa water for another
ten-minute period.
8. ROTATE THE DIVERTER LEVER(S) TO OPPOSITE
POSITION.
Activate the clean cycle as described in step 5. Test the
spa water for Free Available Chlorine (FAC) residual. If the residual
is between 3 and 5 ppm on the test strips (between 1-5 ppm if using
the ACE system) go on to the next step. If the residual is less than
3 ppm, superchlorinate the spa water by adding 1½ teaspoons of
chlorine (sodium dichlor) per 950 liters (250 gallons) of spa water.
Then Activate the clean cycle again to circulate the spa water for
another ten-minute period. Repeat this procedure until both diverter
lever(s) operating positions have been tested.
G S
ettInG tarted

EQUIPMENT COMPARTMENT

The illustration below is to be used as a reference
only (your spa may look different). The equipment
compartment is located behind the front panel of the spa
below the control panel.
EQUIPMENT COMPARTMENT
1. Wavemaster
2. No-Fault heater
™
3. SILENT FLO 5000 circulation pump
4. IQ 2020 ™ control box
Getting Started
1
3
6
jet pump
™
9. RECHECK
the Total Alkalinity (TA) at 80 ppm, Calcium Hardness
(CH) at 100 ppm (if using ACE system 50 ppm), then spa water pH
at between 7.2 and 7.8. using a FRESHWATER 5-way test strip.
Make sure you adjust your Total Alkalinity first, as
IMPORTANT:
an out-of-balance condition will affect your ability to adjust the pH
correctly, and will prevent the sanitizer from operating effectively.
The spa is ready for use when the spa water has circulated
through each diverter lever operating position and the chlorine
level remains between 3 ppm and 5 ppm.
10. TEST WATER WEEKLY OR BEFORE EACH TIME
THE SPA IS USED
7
5
5. Ozone injector
6. Drain (with shut-off valve)
7. Bonding terminal
Page 7
4
1
2