Equipment Compartment - HotSpring Highlife Series Owner's Manual

9. ROTATE THE SMARTJET SYSTEM LEVER(S) TO 2ND
POSITION
(9 O'CLOCK) Activate the clean cycle as
described in step 5 to turn on the cycle for ten minutes to circulate
the spa water. Test the spa water for Free Available Chlorine (FAC)
residual. If the residual is between 3 and 5 ppm on the test strips
(between 1-5 ppm if using the ACE system) go on to the next step.
If the residual is less than 3 ppm, superchlorinate the spa water by
adding 1½ teaspoons of chlorine (sodium dichlor) per 950 liters
(250 gallons) of spa water. Activate the clean cycle again to circulate
the spa water for another ten-minute period. Repeat this procedure
until both SMARTJET lever(s) operating positions have been
tested.
Getting Started

EQUIPMENT COMPARTMENT

The illustration below is to be used as a reference
only (your spa may look different). The equipment
compartment is located behind the front panel of the spa
below the control panel.
EQUIPMENT COMPARTMENT
1. Wavemaster
2. NO-FAULT heater
3. SILENT FLO 5000 circulation pump
4. IQ 2020 control box
™
* This drain may be reversed with other drain depending on your spa, the Main drain will always have a shut-off valve attached.
Page 7
1
3
6
jet pump
™
10. RECHECK
the Total Alkalinity (TA) at 80 ppm, Calcium Hardness
(CH) at 100 ppm (if using ACE system 50 ppm), then spa water pH
at between 7.2 and . using a FRESHWATER 5-way test strip.
Make sure you adjust your Total Alkalinity first, as
IMPORTANT:
an out-of-balance condition will affect your ability to adjust the pH
correctly, and will prevent the sanitizer from operating effectively.
The spa is ready for use when the spa water has circulated
through each SMARTJET lever operating position and the
chlorine level remains between 3 ppm and 5 ppm.
11. TEST WATER WEEKLY OR BEFORE EACH TIME
THE SPA IS USED
8
5
Page 7
5. Ozone injector
6. *Main drain (with shut-off valve)
7. *Secondary drain
8. Bonding terminal
4
1
2
7
Getting Started