Technical Safety Notes For Assembly And Installation; Intended Use; Modifications And Alterations - Fasel Elektronik FCU 00 Series Installation Instructions Manual

Table of Contents

Advertisement

Safety
1.2

Technical safety notes for assembly and installation

1.3

Intended use

Depending on the version, the FASEL sauna controls of the series FCU2x00, FCU3x00 and FCU4x00 are
exclusively meant for operation and control of saunas, saunas with moisture and infrared cabins. The control
devices are permitted for operation in houses and commercial facilities.
Intended use
Claims of any type due to damages caused by improper use will not be accepted. Only the user is
responsible for damages caused by improper use.
1.4

Modifications and alterations

Modifications and alterations of the sauna control or installation can lead to unforeseen dangers.
All technical modifications and add-ons to the sauna control require the written permission of the
manufacturer.
6
– DANGER!
– The control device can be installed directly on the outer side of the
cabin or at another location, however not within the cabin
– Use the sauna control device only with a cover guard for sauna
heaters if one of the following option is enabled:
timer option (lockable in service menu)
remote start via option input, WEB-Control or App
– Appropriate VDE applies to public saunas, that a control lamp,
showing, that the heater is switched on, is to install in the room of the
supervisor.
– This lamp can be connected to the clamp
– For switching off the mains, the power supply cable must be
equipped with a fuse with a contact opening width corresponding to the
requirements of the excess voltage category III for total disconnection.
– At FCUxxxx the main switch of the control unit must be accessible.
– The sensor of the thermostat must be installed in such a way that it is
not affected by the incoming cool air.
WARNING!
Danger if not used correctly
Any improper use of the sauna control can lead to dangerous situations.
Therefore:
– Use the sauna control correctly.
– Operate the sauna control only within the permissible room
temperature and moisture range.  See technical data
– All the specifications in the operating manual and the installation
manual must be strictly adhered to.
Installation instructions Sauna control Series FCUxx00 / Version V 2.27
(FLE-STB).

Advertisement

Table of Contents
loading

Table of Contents