Polycom DOC2231A Getting Started Manual page 27

Table 2-1: IP Configuration Options
Option
IP Address
Subnet Mask
Default Gateway
Make sure no blank spaces occur at the end of each line.
3. Save the changes in the LAN.cfg file.
4. Use the Microsoft Unplug or Eject Hardware procedure prior to
removing the Flash disk.
Failure to stop the hardware properly can result in a corrupt Compact Flash disk.
When the disk fails, a replacement is required.
5. Remove the Compact Flash disk from the reader.
6. Insert the Compact Flash disk into the Compact Flash slot of the MGC+
Control Module.
7. Press the Reset button on the MGC+ unit.
The Options menu appears.
8. Press 1, to Change the MGC+ IP Settings.
If no monitor is connected, the automatic default time-out (15 seconds) selects
option 1.
The Flash Memory LED must be active and flash.
MGC+50/MGC+100 Getting Started Guide
Description
The system displays the currently defined IP address.
Enter the IP address allocated to the MCU by the
network administrator.
Enter the Subnet Mask of the MCU.
Enter the IP Address of the default gateway/router.
2-15