Connecting The Mgc+100/Mgc+50 To The Local Network; Connecting The Mgc+ To The Conferencing Network; Connecting The Mgc+ To The Isdn/ T1-Cas Network - Polycom DOC2231A Getting Started Manual

Connecting the MGC+100/MGC+50 to the Local Network

Connecting the MGC+ to the Conferencing Network

3. Turn on the power by pressing on the power switch located on the rear
panel of the MGC+100/ MGC+50 unit.
The MGC+ must be connected to the local LAN network to enable
communication between the MGC+ unit and the PC workstations running the
MGC Manager application.
Connect one end of a network cable to the LAN connector on the rear I/O
panel of the MGC+ Control Module and the other end to the network.
LAN
VGA
MOUSE
KEYBOARD
COM1
The installation of the MPI box on the MGC+ unit and the connection to the MPI
Network module are described in the MGC+ Hardware and Installation Manual,
Chapter 2.

Connecting the MGC+ to the ISDN/ T1-CAS Network

The ISDN network is optional. If the MGC+ has to be connected to the public
ISDN network then an external CSU or similar equipment is needed.
T1-CAS network is optional. It allows you to connect Audio Only participants to
conferences via T1-CAS lines. It uses the same network connections as ISDN
and the procedure described below is applicable to both ISDN and T1-CAS
lines.
MGC+50/MGC+100 Getting Started Guide
2-11