Battery Installation - Hubsan H507A X4 STAR PRO User Manual

S/N Key/Switch
1 Throttle/Rudder stick
2 Elevator/Aileron stick
Elevator/Rudder Stick
(1)
Throttle /Aileron stick
(2)
3 Power key
Return to Home
4
Auto Takeoff/Auto Land
5
Transmitter status LED
6
Bluetooth status LED
7
8 Photo key
9
Video key
Camera head adjustment
10
key

2-2 Battery installation

PULL
If applicable, remove the
compartment screw. Slide open
the compartment hatch.
● Do not mix new and old batteries
● Do not cross-use different types of batteries at the same time
Function
Push the stick forward or backward and the quadcopter will ascend or descend
(respectively). Push the stick left or right and the quadcopter will rotate
counterclockwise or clockwise (respectively).
Push the stick forward or backward and the quadcopter fly forwards or backwards
(respectively). Push the stick left or right and the quadcopter will fly left or right
(respectively).
Push the stick forward or backward and the quadcopter fly forwards or backwards
(respectively). Push the stick left or right and the quadcopter will rotate
counterclockwise or clockwise (respectively).
Push the stick forward or backward and the quadcopter bwill ascend or descend
(respectively). Push the stick left or right and the quadcopter will fly left or right
(respectively).
Long press for 1.5 seconds and the transmitter will power on. To power off,
long press for 1.5 seconds while the transmitter is on.
Long press for 1.5 seconds and the quadcopter will perform a Return to
Home. To terminate Return to Home, short press for 0.5 seconds.
Long press for 1.5 seconds and the quadcopter will perform an Auto Takeoff or
Auto Land (if the unit is airborne).
When the transmitter is powered on, the LED should be solidly lit. If the
transmitter is low on power, the LED will flash rapidly.
If the transmitter and quadcopter fail to pair or they are simply disconnected
because the quadcopter is powered off, the LED will slowly flash blue. If the
transmitter and quadcopter are successfully connected, the LED will turn solid blue.
Short press the key to take a photo.
Short press once to start the recording; short press again during the
recording to stop the recording.
Temporarily no function.
Insert 4 AAA batteries into the battery
compartment. Take note to make sure you
have correctly matched the polarities.
8
PUSH
Slide the compartment hatch
to close it; if applicable screw it
shut.