Chapter 4 Maintenance And Troubleshooting; Inspection; Cleaning - ZOLL SurePower Single Bay Charger Operator's Manual

This chapter describes a series of non-technical operational checks that you should perform
annually to ensure the proper operation of the SurePower Single Bay Charger.

Inspection

Begin by inspecting the charger to ensure that it's clean (with no fluid spills). Make sure that
nothing has been placed on top of the charger and that there are at least four inches of clear
space around the charger so that it can dissipate heat effectively.
You can then perform the following quick, non-technical operational checks
1. Inspect for cracks or damage to the charger housing.
Inspect the AC cord for severe kinks or exposed wires
2.
3. Connect the charger to live AC mains. The charger will beep, turn on the fan, and light all
LEDs for several seconds. The Power LED will remain lit after the other LEDs go off.
With the battery bay empty, check that all LEDs on the control panel except the Power LED
4.
are off.
Press the Test button. Veryify that all LEDs are temporarily lit.
5.
Inspect the battery pin contacts and the plastic around the battery pin contacts for wear or
6.
damage.
Insert a battery into the bay. Verify that the appropriate LEDs in the bay immediately
7.
illuminate.

Cleaning

Clean the SurePower Single Bay Charger with a soft cloth, mild soap, and water.
Note:
2% glutaraldehyde solution (Cidex)
•
Chlorine bleach (30ml/l water)
•
Isopropyl alcohol 99%
•
Hydrogen peroxide solution
•
Cotton swabs to clear vents
•
Do not immerse or spray any part of the SurePower Single Bay Charger with water. Do not use
ketones (MEK, acetone, etc.). Do not autoclave the SurePower Single Bay Charger.
Do not use chlorine to clean the battery pin contacts.
9650-000272-05 Rev. B
You can also use the following materials to clean the unit:
SurePower Single Bay Charger Operator's Guide
Maintenance and
Troubleshooting
Chapter 4
4-1