Powering On The Charger; Self Test At Power On - ZOLL SurePower Single Bay Charger Operator's Manual

C 2 S U
HAPTER ET P
The charger rests on four rubber feet when you place it on a table top or counter
Figure 2-2 SurePower Single Bay Charger Bottom View

Powering on the Charger

To power on the charger, plug the AC cord into the power inlet of the charger, and then plug the
cord into live AC mains.
Connect the AC cord only to a proper hospital grade receptacle.
Use only the AC cord that ZOLL Medical Corporation provides.
Note:
Position the SurePower Single Bay Charger so that the AC cord is easy to disconnect.
Warning! Always inspect the AC cord before use. Do not use the AC cord if it is defective -- for
example, the cord's insulation is cracked or the cord is severely kinked.

Self Test at Power On

When you connect to the AC mains, the charger performs a self-test which briefly lights all
LEDs and then sounds an audible alarm tone. After a few seconds all LEDS, except the Power
LED to the right of the control panel, will go out. Should the charger detect a fault with its
operation, it will light the Fault LED
Care in the set up of the SurePower Single Bay Charger - correct placement, inspection, and
observation of the Self Test - ensures the usability and performance of the unit.
2-2
There is no power switch on the SurePower Single Bay Charger -- the unit is powered
on at all times it is plugged in and AC power is available.
www.zoll.com
.
AC power inlet
9650-000272-05 Rev. B