Chapter 2 Set Up - ZOLL SurePower Single Bay Charger Operator's Manual

This chapter describes how to properly set up the SurePower Single Bay Charger for use.
Place the SurePower Single Bay Charger on a stable, secure surface.
Position the charger so that the control panel and LED's face the area from which you'll be
working -- this will make it easier to see the LED's and install and remove batteries.
Make sure that there are at least four inches of clear space surrounding the charger. This provides
the air circulation necessary for the charger to dissipate the heat that it generates during
operation.
Figure 2-1 SurePower Single Bay Charger Setup
Caution • Do not place anything on top of or beneath the unit that might block the vents.
• Do not remove or discard the charger's port connector plug -- removal of the plug makes the
unit susceptible to water and dust ingress. Do not connect any cable or device to the charger's
port connector -- the port connector is only for factory use.
Warning! • Do not place open containers of liquids (drink cups, etc.) on or near the charger.
Spilling liquids on the charger can result in an electrical safety hazard.
• Do not the use the charger in a patient environment.
• Always inspect the charger exterior before use; do not use if the exterior is broken.
Cracks or openings caused by damage in the plastic case can result in an electrical
safety hazard.
9650-000272-05 Rev. B SurePower Single Bay Charger Operator's Guide
Chapter 2
Set Up
Port connector plug
for factory use only
2-1