De-Registration Programming - Tadiran Telecom Emerald ICE Quick Start Manual

System Registration and Deregistration

De-Registration Programming

If a user wants to de-register all handsets or remove one handset only,
they can perform de-registration of the handset by the base unit. The
handset unit must be moved to a position near the Base Unit to receive
a de-registration command. After de-registration, the handset unit won't
link with the base any more.
There are 2 ways to de-register the handset unit.
Deregistration Both Hansets at Once Using the Base Unit
1. Unplug Line 1 from the rear of the Base Unit.
2. Set Base Unit DIP switches as follows:
DIP SWITCH-1 to OFF (up)
DIP SWITCH-2 to OFF (up)
DIP SWITCH-3 to ON (down)
3. Plug Line 1 into the marked receptacle on the rear of the Base
Unit. The LED on the base will flash [Fast].
After 30 seconds, the handsets will be deregistered.
4. Turn all of the DIP SWITCH on the base unit to OFF (up).
Note:
The LED on the base will flash [Normally] when the unit comes
back to normal mode.
Emerald ICE Cordless Handset Quick Start Guide
Page 2-1