Installation Of Signal Lamp (Option) - ABB IRB 260 Product Manual

2.3.7 Installation of signal lamp (option)

General
As an option, a signal lamp can be installed on the robot. The lamp is activated
when the controller is in the MOTORS ON state.
Signal lamp on robot
The signal lamp is installed on the upper arm, as shown in the figure below.
xx0500002125
A
B
C
D
3HAC026048-001 Revision: E
Note
Do not use the Signal Lamp option in a Clean Rom environment.
Indicator lamp
Lamp holder
O-ring
Cable gland
© Copyright 2006-2013 ABB. All rights reserved.
2 Installation and commissioning
2.3.7 Installation of signal lamp (option)
Continues on next page
75