Adjustment With The Display And Adjustment Module Plicscom; Short Description; Insert Display And Adjustment Module - Vega VEGADIF 65 Operating Instructions Manual

6 Adjustment with the display and adjustment module PLICSCOM
Mount/dismount display
and adjustment module
42
6 Adjustment with the display and
adjustment module PLICSCOM
6.1

Short description

The display and adjustment module is used for measured value
display, adjustment and diagnosis. It can be mounted in the following
housing versions and instruments:
•
All continuously measuring sensors in single as well as double
chamber housing version (optionally in the electronics or terminal
compartment)
•
External display and adjustment unit
6.2

Insert display and adjustment module

The display and adjustment module can be inserted into the sensor
and removed again at any time. It is not necessary to interrupt the
power supply.
Proceed as follows:
1. Unscrew the housing lid
2. Place the display and adjustment module in the desired position
on the electronics (you can choose any one of four different posi-
tions - each displaced by 90°)
3. Press the display and adjustment module onto the electronics
and turn it to the right until it snaps in
4. Screw housing lid with inspection window tightly back on
Disassembly is carried out in reverse order.
The display and adjustment module is powered by the sensor, an ad-
ditional connection is not necessary.
VEGADIF 65 • 4 ... 20 mA