B7 Two Delay Timers; B8 Two Custom Linearizers; B9 Template Customization; B10 Connecting The Commander Pc Configurator - ABB COMMANDER 351 User Manual

B7 Two Delay Timers

• Programmable delay and duration (0 to 9999 seconds)

B8 Two Custom Linearizers

• 15 breakpoints per linearizer
• The source can be any analog signal

B9 Template Customization

Each template can be customized by changing the sources for various functions in the
COMMANDER 350. This allows maths blocks and custom linearizers to be added into the standard
template format.
The following sources can be programmed:
• process variable inputs
• set point inputs
• position feedback input
• input to ratio/bias block
• ratio inputs
• bias inputs

B10 Connecting the COMMANDER PC Configurator

Note. The COMMANDER 350
must be in Configuration Mode
(levels 6 to E) and Modbus serial
communications
disconnected when using the PC
Configurator.
Fig. B1 Connecting the COMMANDER PC Configurator
APPENDIX B – COMMANDER CONFIGURATION EDITOR
RS232 Serial Port
must be
3 5 0 .
5 0
87