ABB COMMANDER 351 User Manual page 34

8
...3 SET UP MODE
3.3 Level 3 – Set Points
Note. Level 3 is not applicable if Auto/Manual Station or Indicator templates are selected.
3. 0 0
LEV. 3
SEtP
3. 0 1
LSP1
500
3. 0 2
LSP2
200
3. 0 4
LSP4
400
3. 0 6
rAtO
1. 0 00
3. 0 7
BIAS
0
•1 Displayed only if a local set point source is selected – see Section 4.5/ Set Point Configuration/
Local/Remote Set Point Source.
•2 Displayed only for templates with a remote set point.
32
Level 3 – Set Points
Note. To select this frame from anywhere in this page,
press and hold the
Local Set Point Value 1
Set the default local set point value.
[Within set point high and low limits, in engineering units – see
Level 9]
•1
Local Set Point Values 2 to 4
[Within set point high and low limits, in engineering units – see
Level 9]
•1
•2 Remote Set Point Ratio
The remote set point value is
(ratio x remote set point input) + bias.
[0.001 to 9.999]
•2
Remote Set Point Bias
[In engineering units]
Continued...
key for a few seconds.
3.00...3.07