ABB COMMANDER 351 User Manual page 65

4.8.2 Analog Output 1
tYP1
ANLG
C. 0 2
AnI. A
NONE
C. 0 3
AN1. H
20. 0
C. 0 4
AN1. L
4. 0
•2
C. 0 5
r1. H
100. 0
•2
C. 0 6
r1. L
0. 0
AN2. A
NONE
•1 If the output is assigned to a control output by the control type, the setting displayed cannot be changed – see
Section 4.2, Basic Configuration/ Control Output Type.
•2 Not applicable if analog output 1 is assigned to a control output.
•1
Analog Output 1 (ao1) Assignment Source
Select the source required to activate Analog Output 1.
See Rear Fold-out/ Table D – Analog Sources.
Analog Output 1 (ao1) Electrical High
The maximum current output required for the analog output.
[0.0 to 22.0mA]
Analog Output 1 (ao1) Electrical Low
The minimum current output required for the analog output.
[0.0 to 22.0mA]
Retransmission 1 Engineering High
The engineering range value at which maximum output is required.
[In engineering units]
Retransmission 1 Engineering Low
The engineering range value at which minimum output is required.
[In engineering units]
Continued...
4 CONFIGURATION MODE...
C02...C06
63