ABB COMMANDER 351 User Manual page 64

...4 CONFIGURATION MODE
4.8.1 Digital Output 1
tYP1
dIG
C. 0 7
dGI. A
NONE
C. 0 8
dG1. P
POS
AN2. A
NONE
•1 If the output is assigned to a control output by the control type, the setting displayed cannot be changed – see
Section 4.2, Basic Configuration/Control Output Type.
•2 Not applicable if digital output 1 is assigned to a control output.
62
•1
Digital Output 1 (do1) Assignment Source
Select the source required to activate Digital Output 1.
See Rear Fold-out/ Table C – Digital Sources.
Digital Output 1 (do1) Polarity
•2
The output can be set to energize for either an active or inactive digital
signal.
POS
NEG
Continued...
– Output energized when source is active.
– Output energized when source is inactive.
C07, C08