ABB COMMANDER 351 User Manual page 71

...4.10 Level E – Calibration
E. 0 5
OFF. 3
8888
E. 0 6
SPN. 3
8888
•1
E. 0 7
FCAL
NO
AUtO
MAN
F. C AL
AUtO
•1
E. 0 8
r. t rV
30
E. 0 9 •1
C. C AL
NO
E. 1 0 •1
O. C AL
NO
rEF
2700
•1 Displayed only if Motorized Valve with feedback output type is selected – see Section 4.2, Basic Configuration.
Analog Input 3 Offset Calibration
100. 3
0. 0
If the and
reverts to the offset value only.
Analog Input 3 Span Calibration
100. 3
0. 0
If the and
reverts to the offset value only.
Position Feedback Calibration
rEF
Select the calibration required.
2700
– No Calibration
NO
– Auto Calibration
AUtO
r. t rV
– Manual Calibration
_AN
30
Fb. L O
100
Regulator Travel Time
[0 to 5000 seconds]
Ensure that the value entered is compatible with the regulator motor, as
this is used to determine the length of travel of the feedback mechanism.
Motorized Valve Feedback – Fully-closed Position
NO – No action
YES – Fully closes the valve automatically and sets the electrical
input to low range value.
Note. Input value flashes when calibration is in progress.
Motorized Valve Feedback – Fully-open Position
NO – No action
– Fully opens the valve automatically and sets the electrical input
YES
to high range value.
Note. Input value flashes when calibration is in progress.
Continued in
Cold Junction Reference Value
4 CONFIGURATION MODE...
Analog Input 3 Value in Engineering Units
Offset [In engineering Units]
keys are not operated for three seconds the display
Analog Input 3 Value in Engineering Units
Span Adjustment
[0.750 to 1.250]
keys are not operated for three seconds the display
E.05...E.10
frame.
69