STARTER MOTOR
b. If any resistance is out of specification,
replace the starter motor.
L
LLL
L LLL
L
L LLL
5. Measure:
• brush length a
Out of specification → Replace the brushes
as a set.
Brush length wear limit
5.0 mm (0.20 in)
6. Measure:
• brush spring force
Out of specification → Replace the brush
springs as a set.
Brush spring force
7.65 ~ 10.01 N
(780 ~ 1021 gf, 27.54 ~ 36.03 oz)
7. Check:
• gear teeth
Damage/wear → Replace the gear.
8. Check:
• bushing
• bearing
• oil seal
Damage/wear → Replace the defective
part(s).
EBS00515
ASSEMBLING THE STARTER MOTOR
1. Install:
• brush seat 1
NOTE:
_
Align the projection a on the rear bracket with
the slot b in the yoke.
8 - 23
ELEC
L
L LLL
L
L LLL
L
–
+
L LLL
L
LLL