Yamaha YFM700RV 2009 Service Manual page 164

3
4
2
7
2
8
4
4
3
d
c
1
5
3
1
1
6
a
b
2
CYLINDER HEAD
2. Install:
• cylinder head
• cylinder head bolts
NOTE:
• Lubricate the cylinder head bolt 1 and 2
threads and mating surface with molybde-
num disulfide grease.
• Lubricate the cylinder head bolts 3 threads
and mating surface with engine oil.
• Install the washers with their blunt surface
facing the bolt seat.
3. Tighten:
• cylinder head bolts 1:
• cylinder head bolts 2:
• cylinder head bolts 3
• cylinder head bolts 4
NOTE:
_
Tighten the cylinder head bolts in the proper
tightening sequence as shown and torque
them in two stages.
4. Install:
• camshaft sprocket
(onto the camshaft)
M MMM M MMM M M MMM
a. Turn the primary pulley counterclockwise.
b. Align the "I" mark a on the A.C. magneto
rotor with the stationary pointer b on the
A.C. magneto cover.
c. Install the timing chain 1 onto the camshaft
sprocket 2, then the camshaft sprocket
onto the camshaft, and then finger tighten
the camshaft sprocket bolts.
d. Make sure the "I" mark c on the camshaft
sprocket with the stationary pointer d on
the cylinder head.
4 - 14
ENG
= 135 mm (5.31 in)
35 Nm (3.5 m · kg, 25 ft · lb)
= 145 mm (5.71 in)
35 Nm (3.5 m · kg, 25 ft · lb)
38 Nm (3.8 m · kg, 27 ft · lb)
10 Nm (1.0 m · kg, 7.2 ft · lb)
M M MMM M M MMM M M MMM M MMM