ADJUSTING THE VALVE CLEARANCE
1
2
2
2
1
1
3 - 13
EAS00049
ENGINE
ADJUSTING THE VALVE CLEARANCE
The following procedure applies to all of the
valves.
NOTE:
• Valve clearance adjustment should be made
on a cold engine, at room temperature.
• When the valve clearance is to be measured
or adjusted, the piston must be at top dead
center (TDC) on the compression stroke.
1. Remove:
• seat
• front fender
• fuel tank
Refer to "SEAT, FENDERS AND FUEL
TANK".
2. Remove:
• intake tappet cover
• exhaust tappet cover 1
• camshaft sprocket cover 2
3. Disconnect:
• spark plug cap 1
4. Remove:
• spark plug 2
5. Remove:
• timing mark accessing screw 1
• crankshaft end accessing screw 2
CHK
ADJ