Table of Contents
Advertisement
Remote Management
User can enable/disable the management of the Access Point from
a remote host. Just tick the <Enable> check box and enter an IP
address of the remote host. Then, only the host with the entered IP
address can access this device.
WIFI Loading Warning Threshold
The threshold value is used by Lantech-Wireless-View.
Lantech-Wireless-View will monitor the WIFI loading, when the
loading is over this value, Lantech-Wireless-View will change the
color of the link line on network topology to notify the user about
condition of the link quality. The threshold value is between 5 and
25.
3.3.1.2 Firmware Update
By selecting the item of Firmware under System, User will see the
screen shown in Figure 3-3-3. This page shows current firmware
version and date. This page also allow user to using TFTP or WEB or FTP
method to upgrade to the new version of firmware.
Using TFTP
On any computer in the network or a compute direct connect to the
AP. Install a TFTP Server utility, and put the firmware file named
'upgradeFW.tar' in a folder.
Run TFTP server utility and specify the folder in which the firmware
file located. Enter the TFTP server IP and click on <APPLY>
button. At the end of the upgrade process, this device may not
respond to commands before the device boots up. This is normal
behavior and do not turn off the Access Point while the firmware is
upgrading.
Using WEB
Click on <Browse> button and select the correct firmware file
path and file name. Then, click on <APPLY> button to start the
firmware upgrade process. At the end of the upgrade process, the
Access Point may not respond to commands while uploading the
firmware. This is normal behavior and do not turn off the Access
Point while firmware is upgrading.
Figure 3-3-3
36
Advertisement
Table of Contents
