Table of Contents
Advertisement
lowest priority will be elected 'root bridge'
Hello Time: Set the bridge's 'bridge hello time' value (seconds).
Forwarding Delay: Set the bridge's 'bridge forward delay' value
(seconds).
Max Age: Set the bridge's 'maximum message age' value
(seconds)
Port Cost: Set the port cost of the port.
Port Priority: Set the port priority of the port (interface). It is used
in the designated port and root port selection algorithms.
P to P: If a bridge port is operating in full-duplex mode, than the
port is functioning as point-to-point. The available options are:
auto, true or false. By default, it is set to auto.
Edge: If a port is operating in half-duplex mode and is not
connected to any further bridges participating in STP or RSTP, then
the port is an edge port. The available options are: yes or no. By
default, it is set to no.
Figure 3-2-18
22
Advertisement
Table of Contents
