Table of Contents
Advertisement
3.9.4.2 OLSR-ADMIN
In this page, user can set the MESH related settings that shows in
OLSR-CONFIG
Change basic settings
Pollrate [0.0-m.n]: This option sets the interval in seconds, which
the mesh scheduler should be poll for events every 0.2 seconds if
the pollrate is set to 0.2. The default value is 0.5.
TC redundancy [0|1|2]: This value controls the TC redundancy
used by the local node in TC message generation. If set to 0 the
advertised link set of the node is limited to the MPR selectors. If set
to 1 the advertised link set of the node is the union of its MPR set
and its MPR selector set. If set to 2 the advertised link set of the
node is the full symmetric neighbor set of the node. The default
value is 0.
MPR coverage [1-n]: This value decides how many MPRs a node
should attempt to select for every two hop neighbor. The default
value is 5.
LQ level [1-2]: This setting decides the Link Quality scheme to use.
If set to 0, the link quality is not regarded and mesh system runs in
OLSR mode (RFC3626). If set to 1, the link quality is used when
calculating MPRs. If set to 2, the route will also be calculated based
on distributed link quality information. This option should
therefore only be set to 1 or 2 if such a setting is used by all other
nodes in the network. The default value is to 2. Please note that if
LQ level is set to 1 or 2, the mesh will not compatible with
RFC3626!
LQ winsize [1-n]: The total number of packets received up to now.
This value starts at 0 immediately after a link has come alive and
then counts each packet. It is capped at the link quality window
size. The default value is 100.
Willingness [0-7]: Nodes participating in an OLSR routed network
will announce their willingness to act as relays for control traffic for
their neighbors. This option specifies a fixed willingness value to be
announced by the local node. 4 is a neutral option here, while 0
specifies that this node will never act as a relay, and 7 specifies
that this node will always act as such a relay. If this option is not
set in the configuration file, then mesh system will try to retrieve
information about the system power and dynamically update
willingness according to this info. The default value is 7.
Figure 3-9-22
186
Advertisement
Table of Contents
