Table of Contents
Advertisement
Figure 3-8-27
Advanced Settings
Peer Node Distance: Set the distance between this device and it's
adjacent. If select 'manual', the distance will be determined by
'Slot time', 'ACK timeout' and 'CTS timeout' three values.
Beacon Period: This item contains the length of the beacon interval.
Enter a value between 20 and 1000 to specify the Beacon Period.
DTIM Period: This item contains the number of Beacon intervals
between Delivery Traffic Indication Message (DTIM). Enter a
number between 1 and 255 to specify.
Fragment Threshold: It is the maximum frame size that wireless
device can transmit without fragmenting the frame. Enter a value
between 256 and 2346 to specify the Fragment Threshold.
RTS/CTS Threshold: Packets larger than the value are transmitted
by the RTS/CTS handshake. Enter a value between 1 and 2346 to
specify the value of the RTS /CTS Threshold.
Tx Power: To set the tx power as off to turn off the tx power, set
auto to let device determine the tx power value automatically, or
set manual to set the tx power value. The max value is depending
on the wireless module.
Rate: Set the bit rate for wireless interface to supporting multiple
bit rates. The value 'Auto' causes the device to use the bit rate
selected by the rate control module.
Layer 2 Isolation: It is used in AP mode only. If enabled, all of the
clients connect to the same AP will not be able to access each
other.
WEP Key Setting: It uses two kinds of WEP Encryption key length:
5-bytes and 13-bytes. The key format can either use 'ASCII' to set
the key values (ie. 0~9, a~z) Or use 'HEX' to set the key value in
hexadecimal. (ie. 0~9, a~f). User can set maximum 4 keys, but
only one key will functional at one time.
164
Advertisement
Table of Contents
