Table of Contents
Advertisement
Using TFTP
On any computer in the network or a compute direct connect to the
AP. Install a TFTP Server utility, and put the firmware file named
'upgradeFW.tar' in a folder.
Run TFTP utility and specify the folder in which the firmware file
located. Enter the TFTP server IP and click on <APPLY> button. At
the end of the upgrade process, this device may not respond to
commands before the device boots up. This is normal behavior and
do not turn off the Access Point while the firmware is upgrading.
Using WEB
Click on <Browse> button and select the correct firmware file
path and file name. Then, click on <APPLY> button to start the
firmware upgrade process. At the end of the upgrade process, the
Access Point may not respond to commands while uploading the
firmware. This is normal behavior and do not turn off the Access
Point while firmware is upgrading.
Using FTP
On FTP server, there should have valid firmware which includes
fs-opn.img and/or kernel-opn.img. On the Firmware Update - FTP
page, enter the IP address of the FTP server, firmware name and
FTP user name and password. Then click on <APPLY> button to
start the firmware upgrade process. At the end of the upgrade
process, the Access Point may not respond to commands before
the device boots up. This is normal behavior and do not turn off the
Access Point while the firmware is upgrading.
3.6.1.3 Configuration Tools
By selecting the item of Configuration Tools under System, the screen
will show in Figure 3-2-4. This page includes three selections:
Restore Factory Default Configuration, Local Backup settings/Restore
settings and Remote Backup Settings/Restore settings.
Figure 3-6-3
109
Advertisement
Table of Contents
