Fingerprint Reader Board - HP EliteBook x360 1020 G2 Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board (includes cable)
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer
on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the fingerprint reader board:
1. Disconnect the fingerprint reader board from the system board (1).
2. Remove the Phillips screw (2) that secures the assembly to the computer.
3. Lift the bracket up at the screw end (3) and remove the fingerprint bracket (4).
4. Remove the fingerprint reader board and cable from the computer (5).
Reverse this procedure to install the fingerprint reader board.
36 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Battery on page 27).
26).
Spare part number
937411-001