Residual Voltage Immunity In Standby Mode; Figure 13. Turn On/Off Timing (Power Supply Signals) - Intel S5000VCL Technical Product Specification

Intel Server Board S5000VCL TPS
®
AC Input
V out
T
AC_on_delay
T sb_on_delay
PWOK
5 VSB
PSON
AC turn on/off cycle
8.2.15

Residual Voltage Immunity in Standby Mode

The power supply shall be immune to any residual voltage placed on its outputs (typically a
leakage voltage through the system from standby output) up to 500 mV. There shall be no
additional heat generated, nor stress of any internal components with this voltage applied to any
individual output, and all outputs simultaneously. It also should not trip the power supply
protection circuits during turn on.
Residual voltage at the power supply outputs for a no load condition shall not exceed 100 mV
when AC voltage is applied and the PSOn# signal is de-asserted.
Revision 2.3
T
T pwok_on
T pwok_holdup
T 5VSB_holdup
T sb_vout

Figure 13. Turn On/Off Timing (Power Supply Signals)

Intel order number: D64569-007
Power and Environmental Specifications
vout_holdup
T pwok_low
T pwok_off T sb_on_delay T pwok_on
T pson_pwok
T pson_on_delay
PSON turn on/off cycle
T pwok_off
AF001024
43