Electrical Safety; Installation Requirements And Transport - Hoffrichter CPAP User Manual

Respiratory therapy device
Hide thumbs Also See for CPAP:
Table of Contents

Advertisement

ELECTRICAL SAFETY

Do not use the device if its housing, cables or power
supply are damaged.
Do not open the device housing under any circumstances.
Inform your specialist dealer if the device develops a fault.
During therapy, do not connect any other line-powered
devices via the RS232 interface at the rear of the device.
Protect the device from water and dampness.
Always unplug the device from the mains before cleaning.
Empty and thoroughly clean any optional humidifi er if you
do not plan to use it for a lengthy period of time.

INSTALLATION REQUIREMENTS AND TRANSPORT

Place the device near your bed on a fi rm and level surface.
A bedside cabinet is ideally suited for this.
During therapy, the device must not be operated in a
drawer, on a closet shelf or behind a partition.
It must be ensured that the air inlet at the rear of the device
is accessible at all times and not obstructed. Drapes,
curtains, paper or other objects must not be located behind
the device.
Do not place the device on the fl oor or under the bed in
order to maintain low dust exposure levels.
Do not put the device close to a source of heat.
Avoid setting up the device at locations where it will be
exposed to direct sunlight.
Make sure you operate the device at a suffi cient distance
from other equipment which could emit electromagnetic
waves such as diathermy devices, cell phones, remote-
controlled toys and microwave appliances.
Empty the humidifi er (optional accessory) before packing
it away in the carrying case.
Safety Information
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bilevel st25AutocpapBilevel st20

Table of Contents