Appendix E Fibrebridge Leds - ATTO Technology SC 5550E Installation And Operation Manual

This section contains information about LED placement on the FibreBridge embedded RAID controller.
The board is setup to use light pipes to bring LEDs out to the enclosure. Future firmware updates will
provide a pinout for a POS header that will drive LED functionality.
LEDs on the connector side are:
Ready/Fault LED lights green to indicate ready, lights
yellow to show a faulted condition, and is off to indicate
not ready.
Ethernet port connector: The right green LED
shows a valid link, off indicates that no link is present,
and blinking indicates activity. The left green LED
indicates 100/1000 MbE speed.
SAS/SATA Device: A green LED lit on indicates
activity and off means no activity.
SAS Host: A green LED lit on indicates activity and
off means no activity.
Exhibit H-1 FibreBridge 6500E DIMs LEDS
xxvii
ATTO Technology Inc. FastStream SC Installation and Operation Manual

Appendix E FibreBridge LEDs

Available LEDs are:
A Ready LED is lighted green to indicate ready and
off to show not ready.
An Alert LED is lighted yellow to show an alert
condition.
Power: A lighted green LED indicates power has
been turned on to the appliance.
SAS Host: A green LED on each connector indicates
activity if it is lit.
SAS/SATA device: A green LED on each connector
indicates activity if it is lit.