Table of Contents
Advertisement
If you have not already completed the instructions on the Quick Start page packed with your
FastStream, use the following instructions to install the FastStream.
Unpacking the packing box; verifying contents
• The FastStream. Note the serial number of your
FastStream unit: ________________________
• DDR2-533 ECC DIMM
• Celerity FC-42ES Host Adapter (5550E)Celerity
FC-84EN Host Adapter (8550E) or ExpressSAS
H6F0 (8250E) Host Adapter.
• Cat 5 Ethernet cable, RJ-45, 6 feet
• RS-232 cable, RJ-11 to DB9, 6 feet
• CD including an Installation and Operation
Manual, firmware, drivers
Installing the FastStream
See
Exhibit 2.2-1
on page 12 for details on the
FastStream mounting holes and components.
1
Ensure you have the following customer-
supplied items available:
• A back panel I/O plate compliant with ATX
specification version 2.1 or greater
• Internal SAS cable
• ATX-compatible storage enclosure
• SAS or SATA drives
2
Ensure the power to the enclosure is off.
3
Install the back panel I/O plate into your
enclosure. (See
Exhibit 2.2-2
representation of a typical backplate.)
Note
ATTO Technology does not supply the
backplate because of the variety of enclosures
available. Contact your enclosure
representative for assistance.
4
Install CacheAssure NV Memory Card (see
Installing CacheAssure (optional)
the option was purchased with the FastStream.
5
Install your FastStream into the enclosure.
Note
The FastStream must be supported at all six
mounting points to prevent excessive flexing.
Flex damage caused by excessive force on an
2.0 Install the FastStream
on page 13 for a
on page 11) if
CacheAssure contents (optional):
• 0244-FINL-000 Non-Volatile (NV) Memory Card
• SPAK-0000-BLK Power Modules
• MISC-0143-R00 Industrial strength adhesive
• HDWS-0205-R45 Standoff mounting screws
CAUTION
CAUTION
FastStream SC RAID controllers and ATTO
host adapters contain components that are
sensitive to electrostatic discharge (ESD).
ESD can cause damage to these
components. Please follow standard
methods to avoid ESD.
improperly mounted circuit board is not
covered by the product warranty.
1
on page 12 displays the FastStream
mounting holes.
6
Connect the 24-pin ATX power connector from
the enclosure to the FastStream.
7
Install the DIMM module (see
page 13).
CAUTION
CAUTION
Use extreme care when installing or
removing the DIMM module to prevent
possible damage.
a. Insert the DIMM module vertically into its
slot on the board, observing the position of
the notch along the bottom of the module to
prevent inserting the DIMM module
incorrectly.
b. Gently press down on the DIMM module
until it snaps into place in the slot.
8
Install the Host Adapter. See
page 4 and
Exhibit 1.3-1
a. Remove the Host Adapter from its anti-
static bag.
b. Remove the blank plate from slot 7 of your
enclosure.
Exhibit 2.2-
Exhibit 2.2-3
on
Exhibit 1.2-1
on
on page 6 for details.
9
Advertisement
Table of Contents
