ATTO Technology SC 5550E Installation And Operation Manual page 16

c. Position the host adapter directly above the
PCIe slot and push the card straight down.
For easier installation, place one end of the
host adapter into the slot first, then gently
push on each end until the unit is seated.
d. To ensure the card is seated completely,
give it an extra uniform push on each end
simultaneously.
e. Install the panel screw to secure the card.
9 Attach FastStream internal SAS I/O cables.
The internal SAS physical interface consists of
the 32-pin SFF-8087 connectors. The internal
cable can be unshielded and should terminate
from the SFF-8087 connector in the enclosure.
a. Plug in the corresponding end of the
internal SAS cable to the FastStream SC
internal SAS connector (port A and/or port
B).
b. Plug in the opposite end of the internal SAS
connector to the corresponding connector
of the enclosure backplane or SAS/SATA
peripheral.
10 Attach a management interface cable.
You may manage the FastStream using either
an RJ-45 Ethernet cable or an RJ-11 serial
cable.The preferred management tool is the
ExpressNAV graphical user interface accessed
through the Ethernet cable.
10
ATTO Technology Inc. FastStream SC RAID Controller Installation and Operation Manual
RJ-45 Ethernet cable: A board-mounted RJ-45
connector at the back I/O panel connects with a
10/100/1000 baseT category 5 or 6 Ethernet
cable. If using an Ethernet network at 1000
baseT, use a category 6 cable to make the
connection. The FastStream ships with Cat 5
cable.
a. Align the tab on the Ethernet cable with the
tab on the Ethernet port of the FastStream.
b. Insert the cable until it positively mates and
locks into place.
RJ-11 serial cable: A board-mounted RJ-11
cable at the back I/O panel makes connection
with an RS-232 serial port for appliance
management.
a. Align the tab on the provided serial cable
with the tab on the RJ-11 serial port of the
FastStream
b. Insert the cable until it positively mates and
locks into place.
c. Insert the other end of the serial cable into
the DB9 port of the PC being used for
appliance control.
11 Install drives into your enclosure according to
the enclosure and drive manufacturers'
instructions.
12 Put the cover back on the enclosure.
13 Power up the unit.