Table of Contents
Advertisement
7
When you have completed your changes, click
Commit.
8
A warning box appears. In the warning box,
verify that you want to complete the
Removing RAID configuration data
If you move single drives between FastStreams
without erasing the drives, you should clean stale
RAID configuration data from the drives, permanently
removing the drive from the RAID Group. This
operation can be performed on drives that belong to a
RAID Group now or have once belonged to a RAID
Group and are labeled Replaced after system scans.
CAUTION
CAUTION
Continue with extreme caution: data is lost
on the drive when it is cleaned of RAID
information.
1
If you are not already in the ExpressNAV
Storage Manager, type the IP address of your
controller in a standard browser. On the splash
screen, click Enter Here. In the box provided,
type in your user name and password, and click
OK.
2
Click the Diagnostics button on the Menu
Items list on the left hand side of the
ExpressNAV Storage Manager.
RAID CLI page
Changes to various parameters may be made using
the RAID CLI page.
CAUTION
CAUTION
Do not use this page unless you are
directed to by an ATTO technician.
Changing parameters may cause loss of
data and/or disruption to the performance
and reliability of the FastStream.
Note
The ExpressNAV Storage Manager is the
preferred method to manage the FastStream.
1
If you are not already in the ExpressNAV
Storage Manager, type the IP address of your
controller in a standard browser. On the splash
screen, click Enter Here. In the box provided,
configuration by clicking on Yes. Clicking on No
ends the procedure without making a change.
9
The Health and Status Monitor screen
appears.
3
Click in the Clean RAID Configuration data
radio button from the Select User Process
box.
4
Click Next.
5
Click on the drives you wish to update; the
drives are highlighted.
6
Click on Commit.
7
A warning box appears. In the warning box,
verify that you want to complete the
configuration by clicking on Yes. Clicking on No
ends the procedure without making a change.
8
When the process is complete, the Health and
Status Monitor screen appears.
type in your user name and password, and click
OK.
2
In the left-hand menu, click on the RAID CLI
menu item.
3
The RAID CLI page appears. Wait for the
prompt, then
Ready
in the text box provided. Refer to
an ASCII-based Interface
Appendix D.
4
Click the Submit button: this is equivalent to
typing in the CLI command into a telnet or serial
port CLI session.
A text field beneath the box lists the most recent
commands issued to the FastStream through this
page. If you enter an incorrect parameter, the CLI help
text is displayed, showing the parameters available.
An asterisk next to the Ready prompt indicates you
must type SaveConfiguration restart in the text box
for changes to take effect.
type in the CLI command
CLI Provides
on page vii of
41
Advertisement
Table of Contents
