ATTO Technology SC 5550E Installation And Operation Manual page 72

Help
The Help command issued with no parameters displays a list of
available CLI commands. When a CLI Command name is
specified, a command usage string and command description
is presented on the CLI.
Help <command>
HSAdd
HSAdd assigns a Block Device to the Hot Spare pool. Optional
parameter "RAID" and RAID Group name is the ASCII name of
the RAID Group for which to reserve a Dedicated Hot Spare;
this means the Hot Spare is assigned solely to the specified
RAID Group. If no Group name is specified, the Hot Spare is a
global Hot Spare and available for use by any RAID Group.
HSAdd <RAID GrpName> [BlockDevID]
HSDisplay
HSDisplay outputs a list of all of the devices in the Hot Spare
pool.
HSDisplay
HSRemove
Removes a Block Device from the Hot Spare pool.
HSRemove [BlockDevID | all]
IdentifyBridge
IdentifyBridge causes the 'Alert' LED to blink to enable
identification of this system. Disable this option to cancel the
blinking.
set IdentifyBridge [enabled | disabled]
get IdentifyBridge
Info
Info displays version numbers and other product information for
key components. Use the optional 'brief' parameter to show a
more concise subset of system information.
Info <brief>
IPAddress
IPAddress controls the current IP address of any Ethernet
port(s). If IPDHCP is enabled, then the 'get' command reports
the current IP address assigned by the network DHCP server,
followed by the (DHCP) identifier.
set IPAddress [mp1] [[xxx.xxx.xxx.xxx] | [[IPv6-
compatible address] [Prefix length]]]
get IPAddress [mp1]
IPDHCP
IPDHCP allows acquisition of an IP address from a network
DHCP server. When this option is disabled, the IP address used
will be specified by the IPAddress CLI command.
set IPDHCP [mp1] [enabled | disabled]
get IPDHCP [mp1]
IPDNSServer
DNSServer controls the current DNS Server address. If
IPDHCP is enabled, then this value is automatically detected. If
IPDHCP is disabled, then this value must be manually set.
set IPDNSServer [xxx.xxx.xxx.xxx]
get IPDNSServer
IPGateway
IPGateway controls the current default gateways used by any
Ethernet port(s). If IPDHCP is enabled, then the 'get' command
reports the current IP gateway assigned by the network DHCP
server.
set IPGateway [mp1] [xxx.xxx.xxx.xxx]
get IPGateway [mp1]
IPSubnetMask
IPSubnetMask controls the current subnet masks used by any
Ethernet port(s). If IPDHCP is enabled, then the 'get' command
reports the current IP subnet mask assigned by the network
DHCP server.
set IPSubnetMask [mp1] [xxx.xxx.xxx.xxx]
get IPSubnetMask [mp1]
IPV6Gateway
IPV6Gateway controls the current default gateway used by the
IPv6 protocol. Unlike the IPGateway command, there is only 1
IPV6Gateway allowed.
set IPV6Gateway [IPv6-compatible address]
get IPV6Gateway
IPV6RemoveAddress
IPV6RemoveAddress removes the manually configured IPv6
network address from the given network interface if that
interface has been manually configured.
IPV6RemoveAddress [mp[n]]
IsReserved
IsReserved displays the reservation status of the current
services session/interface.
IsReserved
xvii