ATTO Technology SC 5550E Installation And Operation Manual page 70

DriveTestList
Specifies drives to be run in the next drive test. DriveTestConfig
should be setup prior to adding any drives into the test list. This
command can be called with different eligible BlockDev IDs and
each one will be added to the list. Drives which are part of a
RAID Group are only eligible for read drive tests. Additionally,
Hot Spare drives are only eligible for mediascan and read drive
tests. The 'all' parameter automatically chooses eligible drives.
The test is not started until the DriveTest Begin command is
given.
set DriveTestList [drive [BlockDevID] | all]
get DriveTestList
DriveTestStatus
Displays the status of the currently running drive test. This
command does not display performance metrics. If a block
device ID is not running or cannot be found, its state will be 'idle'
and percent complete will be 0.
get DriveTestStatus <drive [BlockDevID]>
DumpConfiguration
Dumps system's configuration.
DumpConfiguration
DumpEventLog
Dumps the contents of the event log to an available RS-232 or
telnet session. The optional parameter is the number of lines to
be displayed as a single page with no user interaction.
DumpEventLog <NumEntries>
EmailFromAddress
EmailFromAddress configures the email address that this
system will use to talk to the email server. Full email address is
a fully qualified Internet email address, not more than 128
characters long.
set EmailFromAddress [full email address]
get EmailFromAddress
EmailNotify
EmailNotify turns on and off email notification. Default is
disabled.
Default: Disabled
set EmailNotify [enabled | disabled]
get EmailNotify
EmailNotifyAddress
EmailNotifyAddress configures notification addresses. Index is
a number between 1 and 5, inclusive. Full email address is a
fully qualified Internet email address, not more than 128
characters long. The level can be "all", "informational",
"warning", "critical" or "none". This is the minimum level of
severity in order for the event to trigger an email notification.
set EmailNotifyAddress [index] [full email address]
[warning level]
get EmailNotifyAddress <index | All>
EmailPassword
EmailPassword sets the password used to authenticate the
login to the SMTP email server. The password must not be more
than 64 characters. A password is not required if the email
server does not require authentication.
set EmailPassword
EmailServerAddress
EmailServerAddress configures the address of the server that
should be contacted in order to send out emails. Either an IP
address or a fully qualified domain (e.g. mail.myserver.com)
may be specified.
Default: 0.0.0.0
set EmailServerAddress [xxx.xxx.xxx.xxx | name]
get EmailServerAddress
EmailUsername
EmailUsername sets the username used to authenticate the
login to the SMTP email server. The username must not be
more than 128 characters. A username is not required if the
email server does not require authentication.
set EmailUsername [username]
get EmailUsername
EthernetSpeed
EthernetSpeed determines the speed of any Ethernet port(s). If
Auto is enabled then the Ethernet speed will be negotiated and
the value in parentheses returned by the 'get' command
indicates the current speed of the Ethernet connection. When
hard set, 10 and 100 speeds are half duplex.
Default: mp1 auto
set EthernetSpeed [mp1] [10 | 100 | 1000 | auto]
get EthernetSpeed [mp1]
EventLog
EventLog can be used to enable/disable the event logging
feature. When enabled, various system events are recorded to
the event log.
set EventLog [enabled | disabled]
get EventLog
xv