Table of Contents
Advertisement
Installing CacheAssure (optional)
If you have opted for a FastStream without the
CacheAssure option, please advance to
on page 12
and continue on.
WARNING
ATTO CacheAssure modules contain
components that are sensitive to
electrostatic discharge (ESD). ESD can
cause damage to the FastStream RAID
Controller. Please follow standard methods
to avoid ESD.
Exhibit 2-1 FastStream (8550E) with CacheAssure
Non-Volatile (NV) Memory Card
Installation
Note
Embedded FastStreams not ordered with the
CacheAssure module are not configured for
CacheAssure installation. CacheAssure is not
a field upgradeable item. Please contact ATTO
for assistance.
1
CacheAssure should be installed while your
storage enclosure is being assembled.
2
Remove the NV Memory Card from its
electrostatic safe packaging.
3
With the FastStream on a ESD safe surface
plug the NV memory card onto the mounting
location (see
Exhibit 2.2-1 on page
4
Make sure the NV Memory Card is firmly
seated by gently pushing the card down onto
the FastStream (see
Exhibit 2.2-1
12).
Exhibit 2.1-1 on page
11).
CAUTION
CAUTION
Make sure the NV memory card is evenly
aligned on both sides. If the card is placed
incorrectly, damage to the memory card or
FastStream may occur and it may void the
product warranty.
5
Turn the FastStream over so that you can see
the back of the printed circuit board. Use the
two supplied screws to finish securing the NV
memory card onto your RAID Controller.
6
Use an ESD-safe crosshead screwdriver to
secure the screws.
Exhibit 2.1-1 NV Memory Card Placement
Power Module Installation
1
Remove the Power Modules from their
electrostatic safe packaging.
2
Select an area for placement of the Power
Modules inside of the enclosure. Make sure
they can be mounted securely and that the
Power Modules' power cord can reach the NV
Memory Card's power jack.
3
Use the heavy-duty, industrial adhesive, shown
in
Exhibit 2-2
to mount the modules. Remove
one side of the paper backing and apply it to the
Power Modules.
Exhibit 2-2 Applying mount adhesive
4
Remove and expose the other side of the
adhesive.
5
Mount the Power Modules into the enclosure.
11
Advertisement
Table of Contents
