Programming - Vacon 100 INDUSTRIAL Installation Manual

Programming

4. P
ROGRAMMING
You will find basic information on how to use the control keypad in the Application Manual of your
®
VACON 100 family AC drive.
Below you will find some examples of navigation paths to the fieldbus parameters.
1. First ensure that the right fieldbus protocol is selected.
'Fieldbus control'
2. Select
3. Activate Remote control.
4. Select controlling fieldbus
5. Set up Protocol Parameters.
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
Table 4.
Activating BACnet MSTP (P5.8.1.1)
Main Menu > I/O and Hardware > RS-485 > Common settings > Proto-
col > BACnet MSTP <
Activating BACnet IP (P5.9.3.1.4)
Main Menu > I/O and Hardware > Ethernet > Bacnet IP > Protocol in
use > Yes <
Remote Control Place
as the
Control Place (P3.2.1)
Main Menu > Parameters > Start/Stop Setup > Rem Control Place >
FieldbusCTRL <
Local/Remote (P3.2.2)
Main Menu > Parameters > Start/Stop Setup > Local/Remote >
Remote <
Controlling Fieldbus (P5.13.1)
Main Menu > I/O and Hardware > Fieldbus General > Controlling
Fieldbus > Automatic/BACnet IP/RS-485 <
BACnet MS/TP parameters see Chapter 4.1
BACnet IP parameters see Chapter 4.2
.
vacon • 7
4