Keypad Operation And Programming; Introduction - Vacon 50X User Manual

39 vacon

5. Keypad Operation and Programming

5.1 Introduction

The Vacon 50X AC drive is pre-programmed to run a standard, 4-pole AC induction motor. For many ap-
plications, the drive is ready for use right out of the box with no additional programming needed. The dig-
ital keypad controls all operations of the unit. The ten input keys allow "press and run" operation of the
motor (Operation mode) and straightforward programming of the parameters (Program mode).
Figure 19: The Vacon 50X Keypad
To simplify programming, the parameters are grouped into three levels:
The parameter table on page 113 shows the standard settings, the table on page 117 the parameter
names in 5 languages and on page 121 the settings and messages in 5 languages. "Vacon 50X Parameter"
describes the individual parameters starting from page 59.
If you want to get started quickly, see the "Quick Start" section on page 57.
5
keypad operation and programming
1. Enter Level 1 by pressing the Program (PROG) key at any time. Level 1 allows you
to access the most commonly used parameters.
2. Enter Level 2 by holding down the SHIFT key while pressing the PROG key. Level 2
allows access to all Vacon 50X parameters, including those in Level 1, for applica-
tions which require more advanced features.
3. Enter Macro mode by holding the Program (PROG) key down for more than 3 sec-
onds. The display then shows "Hold PROG for Macro Mode." See Chapter 6, "Using
Macro Mode and Getting a Quick Start", starting on page 49, for more information.
Tel. +358 (0)201 2121 • Fax +358 (0)201 212205