Table of Contents
Advertisement
Set Location Information
Department to use with Location Control enabled or with a GPS. You can
program a circle with a radial range or multiple rectangles as a location. See Set
Up GPS first.
Circle
Set Latitude
Enter the latitude. Press .no to toggle N or S, and press E/yes.
Set Longitude
Enter the longitude. Press .no to toggle E or W, and press E/yes.
Set Range See also Understanding Range.
0-6000
Rectangles
New Rectangle
Latitude -Top Left
Enter the latitude. Press .no to toggle N or S, and press E/yes.
Longitude -Top Left
Enter the longitude. Press .no to toggle E or W, and press E/yes.
Latitude - Right Bottom
Enter the latitude. Press .no to toggle N or S, and press E/yes.
Longitude - Right Bottom
Enter the longitude. Press .no to toggle E or W, and press E/yes.
Rectangle
Edit Rectangle See Rectangles above.
Delete Rectangle
At Confirm Delete? press E/yes or .no.
Set Avoid
This determines whether a Department will be scanned or not.
Temporary Avoid cancels when you cycle power.
The default setting is Stop Avoiding.
Temporary Avoid, Stop Avoiding, or Avoid
See also Scan Avoids.
Delete Department
At Confirm Delete? press E/yes or .no.
New Department
Department Options
This allows you program a location for the
Deletes the Department.
See New Department.
53
Advertisement
Table of Contents
