Table of Contents
Advertisement
Set Delay Time
ends before resuming Quick Search and Close Call Search operations.
A negative delay will force a resume after that number of seconds.
The default setting is 2 seconds.
-10, -5, -2, 0, 1, 2, 5, 10, or 30 sec.
Set Attenuator
operations by about 20dB. The default setting is Off.
On or Off
See also Search Attenuation.
Set Audio AGC
off for Quick Search and Close Call modes. The default settings are Off.
Analog - Press E/yes to toggle On or Off.
Digital - Press E/yes to toggle On or Off.
P25 Waiting Time
frequencies have digital or analog transmissions. During this time, the scanner
will evaluate the received signal and, if it detects digital data, will open squelch
immediately. If digital is not detected before the delay expires, the scanner will
open squelch at the end of this delay. This is to prevent "false decode" problems.
The default setting is 400 ms.
0 to 1000 ms
Note: Any analog transmissions will lose the first part of the transmission, up
to the wait time you set here.
P25 Threshold Mode
Auto -
Manual -
Default -
P25 Threshold Level
1 to 20
Search/Close Call Options
Determines how long the scanner waits after a transmission
This controls the attenuator for Quick Search, and Close Call
This allows you to turn AGC (Automatic Gain Control) on or
This setting gives the scanner time to determine if
The default setting is Auto.
The default setting is 8.
75
Advertisement
Table of Contents
