Table of Contents
Advertisement
The Wi-Fi dongle allows you to connect to the scanner wirelessly and control your
scanner with the Remote software.
The scanner has two different Wi-Fi connection modes, Infrastructure Mode and
Access Point Mode.
Infrastructure Mode is able to connect to an Access Point device.
With this mode, all you need to do is a set a password. In a few cases, there is no
password needed with the Access Point unit.
Access Point Mode is able to connect with up to 5 clients.
Setting parameters are as follows: SSID, Security type, and Password.
Make sure the Wi-Fi dongle is connected to the USB port behind the scanner.
Press Menu then scroll to Wi-Fi Setup and press E/yes.
Scroll to the Favorites List and press E/yes.
Scroll to Edit Favorite and press E/yes.
Show Wi-Fi Information
Shows the IP address, MAC number, and version when connected.
Shows 'Wi-Fi not connected'.
Set Connection
Off Not connected.
Infrastructure Mode – Routers etc.
Select AP Select the access point with the encryption type.
Password See Data Naming.
Access Point Mode – Laptops, Smart devices etc.
Input SSID
Enter (or use default) name of connection. See Data Naming.
Select Security
Open, WEP, or WPA/WPA2
Input Password See Data Naming.
Reset to Factory
At Confirm Delete? Press E/yes or .no.
Wi-Fi Setup
Wi-Fi Options
(BCD536HP Only)
39
Advertisement
Table of Contents
